Gauss
Ignition Coil - GC4015
Brief Specifications
Related Image
38841
Number of Pins
2
Ignition Module
NO
Test Observations
In this coil, each pin “C” (coil) of the connector controls two high voltage outputs of the coil, therefore, the outputs must be tested in pairs, according to the numbers indicated in the image. To perform the test, follow the procedure below:
• Connect one of the PU02 set cables between the “R/INT” output and the “B+” pin on the coil and the other cable between the “NEG” output and the “C” pin that controls a pair of coil outputs
• Connect the high voltage cables from the equipment to the high voltage outputs of the coil, noting that the outputs are related to the connected input pin
• Activate the Modules/Coils test section and observe the spark gap. There must be a spark in two electrodes, indicating the correct operation of the two outputs being tested
• Disable the Modules/Coils test section and switch the “NEG” cable from one “C” pin to the other, which controls another pair of outputs. Switch the high voltage cables from the previous outputs to the new ones and repeat the test. Again, there must be a spark in both electrodes
Brief Application
Brand
Model
BUICK
CENTURY Coupe (4A_)
BUICK
CENTURY Saloon
BUICK
CENTURY Station Wagon (4_35)
BUICK
LA CROSSE Saloon
BUICK
LESABRE
BUICK
LESABRE Coupe
BUICK
LUCERNE Saloon
BUICK
PARK AVENUE
BUICK
REGAL
BUICK
REGAL (4WF_)
Related Image
38841
Number of Pins
2
Ignition Module
NO
Test Observations
In this coil, each pin “C” (coil) of the connector controls two high voltage outputs of the coil, therefore, the outputs must be tested in pairs, according to the numbers indicated in the image. To perform the test, follow the procedure below:
• Connect one of the PU02 set cables between the “R/INT” output and the “B+” pin on the coil and the other cable between the “NEG” output and the “C” pin that controls a pair of coil outputs
• Connect the high voltage cables from the equipment to the high voltage outputs of the coil, noting that the outputs are related to the connected input pin
• Activate the Modules/Coils test section and observe the spark gap. There must be a spark in two electrodes, indicating the correct operation of the two outputs being tested
• Disable the Modules/Coils test section and switch the “NEG” cable from one “C” pin to the other, which controls another pair of outputs. Switch the high voltage cables from the previous outputs to the new ones and repeat the test. Again, there must be a spark in both electrodes
Compare and find the
ideal product for you!
No se seleccionó ningún producto.
Continúe navegando y seleccione productos para compararlos.
Continúe navegando y seleccione productos para compararlos.
