Gauss
Crankshaft Position Sensor - GS8009
Brief Specifications
Type
Inductive
BT010 - Order
- SIGNAL *
Terminals (Qty)
3
Test Observations
This type of sensor has three terminals, but only two are connected to an inductor that generates the voltage signals when varying the magnetic field. The third terminal is a shield around the cable to avoid interference and is connected to the vehicle ground. You do not need to connect it to perform this test.
To perform the test, follow the procedure:
1. In the sensors test module, adjust the LCD display to show the frequency
2. Connect the sensors test cables (PU02) to the available “IN” and “GND” inputs below the LCD display and the smaller terminals on the sensor to be tested, as shown in the image
3. Connect the Auxiliary Coil (BA01) to the “R/EXT” and “NEG” inputs available on the coils test module. It will generate the magnetic field required for the sensor operation
4. Activate the “Modules/Coils” test module and bring the Auxiliary Coil tip closer to the speed sensor tip. The sensor will start generating the signal and the LCD display should show the value of the sensor operating frequency
5. The frequency can be changed between 50Hz and 400Hz by pressing the speed button on the “Modules/Coils” test module and, by changing the speed, the frequency shown on the LCD display must also vary
Type
Inductive
BT010 - Order
- SIGNAL *
Terminals (Qty)
3
Test Observations
This type of sensor has three terminals, but only two are connected to an inductor that generates the voltage signals when varying the magnetic field. The third terminal is a shield around the cable to avoid interference and is connected to the vehicle ground. You do not need to connect it to perform this test.
To perform the test, follow the procedure:
1. In the sensors test module, adjust the LCD display to show the frequency
2. Connect the sensors test cables (PU02) to the available “IN” and “GND” inputs below the LCD display and the smaller terminals on the sensor to be tested, as shown in the image
3. Connect the Auxiliary Coil (BA01) to the “R/EXT” and “NEG” inputs available on the coils test module. It will generate the magnetic field required for the sensor operation
4. Activate the “Modules/Coils” test module and bring the Auxiliary Coil tip closer to the speed sensor tip. The sensor will start generating the signal and the LCD display should show the value of the sensor operating frequency
5. The frequency can be changed between 50Hz and 400Hz by pressing the speed button on the “Modules/Coils” test module and, by changing the speed, the frequency shown on the LCD display must also vary
Compare and find the
ideal product for you!
No se seleccionó ningún producto.
Continúe navegando y seleccione productos para compararlos.
Continúe navegando y seleccione productos para compararlos.
